AC System Oil Analyzers (single use disposable)
See
chart used to interpret readings.
These little oil analyzers are shown below. To check the status
of the AC system oil without having to open up the system! How cool is that?
Directions:
1. Start the engine
2. Switch on AC and turn down the blower
3.
Wait approx. 60 seconds
4. Put the oil phase tester on the low side valve and
press the oil phase tester 2-3 times
5. Match the appearance of the oil phase tester to the chart on
this page
The tester measures the cleanliness/condition of the system oil
as well as how full or empty it is.
Buy them by the dozen. Each individual tester will test oil
conditions and level once. Test it once to determine oil condition, remedy the
oil condition by adding, replacing oil etc. then test again with another
tester to verify corrections made to the oil.
The price for these are 97
cents per oil phase tester:
Please,
include service port fitting size in the "message section" as you order to insure
you get proper size testers. Do you want R-12 or 134a
testers???
